DPA OM EN 20180510

Thank you very much for choosing Delta DPA series pressure sensor. Please read this instruction sheet carefully before using your DPA. Keep this instruction sheet handy for quick reference. WarningDANGER! CAUTION! ELECTRIC SHOCK! DPA is a pressure measurement device. DO NOT use it out of its specification. Improper pressure or incorrect wiring may cause series injuries on staff or damages on other devices. 1. Keep away from high-voltage and high-frequency environment during the installation in case of interference. Prevent using the device in premises which contain: (a) dust or corrosive gas; (b) high humidity and high radiation; (c) shock and vibration. 2. DPA can only be used for air pressure measurement and should avoid corrosive, inflammable or toxic gas measurement. 3. Make sure the power supply is switched off when installing or dismounting DPA and the pressure source stops its action in case harms occur on human body and properties. 4. DO use parts compatible to the specification of the pressure pore for connection to avoid mistaken measurement or safety problems. 5. Before switching on the power supply, check the signal connection, e.g. the input voltage and polarity. Voltage that is too high may cause damages on DPA. 6. DO use dry cloth and DO NOT use acid or alkaline liquid to clean the device. Product Profile & Outline1. Analog output indicator 2. Digital output 1 indicator 3. Digital output 2 indicator 4. Pressure/parameter display 5. SV/setup item display6. UP key 7. SET key 8. DOWN key 9. Power supply and output terminals 10. Pressure input pore Contents in the pack: Pressure sensor, signal wire, unit sticker, instruction sheet  Optional accessories: Panel mounting parts, metal mounting parts-1- Ordering InformationSeries nameDPA: Delta DPA series pressure sensor 01: -100kPa ~ 100kPa 10: -100kPa ~ 1,000kPa N: NPN output + 4 ~ 20mA; P: PNP output + 4 ~ 20mA M: NPN output + 1 ~ 5V; Q: PNP output + 1 ~ 5V P: Outer pore PT 1/8, inner pore M5 N: Outer pore NPT 1/8, inner pore M5 G: Outer pore G 1/8, inner pore M51 2Measurable pressure range3 Output types 4 Pressure pore types Electrical SpecificationsPower supply Voltage range Power consumption Pressure type Measurable range Pressure measurement 12 ~ 24V DC +/- 10% no isolation 40mA Max.; current output type 60mA Max. Non-corrosive gas, gauge type DPA01: -100kPa ~ 100kPa DPA10: -100kPa ~ 1,000kPa DPA01: 200kPa DPA10: 1,500kPa +/- 3% entire process +/- 2% entire process 2-line LCD display, 4 digits for measured value and 3.5 digits for setup display LCD output status display 3 colors for different modes 100ms, 250ms, 500ms, 1,000ms Built-in 2 NPN or PNP transistor digital outputs and 1 analog output NPN: Max. durable pressure 30V/100mA, residual voltage 1.5V PNP: Max. durable pressure 30V/100mA, residual voltage 1.5V 1 ~ 5V: Min. output load resistance 1,000Ω 4 ~ 20mA: Max. output load resistance 400Ω; linear inaccuracy 2% entire process 2ms, 4ms, 10ms