ADVISOR CD 3403

Thank you for choosing an ARITECH security system. When properly maintained, the system will provide years of reliable operation. This manual explains how to use the ARITECH CD34 series for every day use. There is a more detailed manual available for managers which explains how to carry out a wider range of operations. The CD34 is a burglar alarm system which can detect an (attempted) break-in using connected detectors, magnetic contacts, etc., generating an alarm. The manual uses symbols to show when you must enter information into the keypad, and when the system emits a beep. Examples of these symbols are shown below:code +You need to enter information into the keypad. What you have to enter is on the right of the symbol. In this example you should enter your code and then press the Accept key ( ). The buzzer on a key switch or keypad emits a long beep. Short beeps can also be emitted - this is indicated with the text ‘Beep Beep’.BeeeepYour system has been programmed with one or two entrance times and one exit time. These are pre-set amounts of time that let you enter and leave the premises through specific routes without activating an alarm. Be sure you know which routes you can use to leave and enter the premises. Entrance time: _________________ seconds Second entrance time: _________________ seconds Exit time: _________________ secondsPage 4User Manual for CD3403USING THE KEYPADThis chapter describes the alarm system keypad.THE CD3008, CD3009, CD3048 & CD3049 KEYPADThe keys0-9 These keys are used to enter your code. Always begin with zero (0) and then enter your code. After entering the code, you can carry out the operations assigned to it. The options assigned to a code can be adjusted by the installer or manager. When you are in an option list, this key can be used to go backwards in the list. During arming you can exclude zones. See Special keys. This key has several functions. When you are in an option list, you can use it to move forward through the list. The other options are listed under Special keys. This key is the Accept key. It is used to confirm that the option shown in the display should be implemented. X This is the Reject key. It is used to indicate that the option shown has not been changed or that you want to exit the option list.Special keysThe following key combinations can be programmed by the installer. They may not be active in your system.Pressing these keys simultaneously will activate a personnel attack alarm. A report can then be sent over the phone lines to the central station, and the bells and flashing light may be activated. Press the ‘ ' key twice to see which zones are still open. All the open zones are displayed or the message ‘All Closed’ appears. Press the ‘ ‘ key twice to see which zones are inhibited. All the inhibited zones are displayed or the message ‘No Inhibits’ appears.User Manual for CD3403Page 5THE DISPLAYThe display is the link between you and the security system. The text messages displayed show where and when faults or alarms have occurred.