HP Scitex FB500 FB700 - service manual

Printer HP Scitex FB500 FB700 - service manual 

Each procedure lists the tools required to complete the task. Below are a list of tools commonly used to service the printer. Additional “special tools” (some that must be ordered as service tools) are listed in the section “Special Tools” on page 486.

• Gloves, such as latex

• Protective eye wear

• Paper towels

• Apron to protect clothing from ink

• Drop cloth to protect floor from dripping ink

• Metric sockets from 10 mm - 17 mm

• Socket extensions (8 cm and 20 cm or 3-in and 8-in)

• Metric open-end wrenches (set)

• 5/8-in open-end wrench (service station drain replacement)

• Metric hex wrench (such as Allen wrench hex keys) set 2 mm - 8 mm (including 2.5 mm and a 3 mm L-shaped)

• 3/32-in hex wrench (carriage calibration)

• 1/16-in or a 1.5 mm hex wrench (to loosen the screw that secures the encoder wheel to the shaft of the media-drive motor).

• #1 and #2 phillips screwdriver (including a ten-inch #2 and a short #2)

• Flat-blade screwdriver

• 10 X Lighted Loupe (y-axis calibration)

• Flexible tube clamps, such as hemostat clamps (minimum of two clamps for any printhead

work).

• Large adjustable wrench, such as a Crescent wrench (for media-drive belt tension)

• Medium-sized adjustable wrench, such as a Crescent wrench

• Internal C-ring pliers (removing c-ring from input-side media-drive bearings - see Fig. 695. on page 490)

• Calipers (used with media-drive belt calibration - see Fig. 696. on page 490)

• Razor knife

• Needle-nosed pliers (lamp fan replacement)

• Head height gauge (ships in accessory box with each printer)

• Long level (1 meter or about 3 feet)

• Short level (30 cm about 1 foot)

• Low-adhesive tape, such as painter’s tape

• Flashlight

• Dial indicator (see special tools on page 487).