Inverter VE.Direct 120V Manual Warning and alarms. For the full list of all LED indications and monitoring parameters, see the Operation [11] chapter. 2.4. The VictronConnect app The VictronConnect app is used to monitor, control and configure the inverter. The app can be installed on a phone, tablet or computer. The app is available for Android, iOS, Windows and macOS. The app either communicates via Bluetooth or via USB interface to the VE.Direct port. For more information about the app and to download the app, see the VictronConnect product page . 2.5. Bluetooth The inverter does not have built-in Bluetooth.
To be able to communicate via Bluetooth use the (optional) VE.Direct Bluetooth Smart dongle . Bluetooth (but also a VE.Direct connection) can be used to communicate with the VictronConnect app. 2.6. VE.Direct port The inverter is equipped with a VE.Direct port. This port can be used to connect the inverter to: The VictronConnect app via a VE.Direct to USB interface . The VictronConnect app via a VE.Direct Bluetooth Smart dongle . The GlobalLink 520 . Note that an additional VE.Direct cable is needed for this. A GX monitoring device, such as the Cerbo GX . Note that an additional VE.Direct cable is needed for this. 2.7.
Remote on/off control The inverter can be remotely turned on or off in the following ways: Via the VictronConnect app. With an (optional) external switch connected to the remote connector. With the (optional) Inverter Control VE.Direct panel connected to the remote connector. From a BMS (Battery Management System) connected to the remote connector. Via a GX device and/or the VRM portal (optional). For more information see the Remote connector [7] chapter. Page 3 General description