HOME 2.22 HAND GRIPS RIGHT HAND GRIP Installation To replace right hand grip, see 7.30 RIGHT HANDLEBAR SWITCH and 2.10 THROTTLE CABLES . 1. Obtain a new left hand grip and Harley-Davidson Adhesive (Part No. 99839-95). Apply a coat of the adhesive to the inside surface of the grip 25.4 mm (1.0 in.) from the open end. Apply a coat to the end of the handlebar. LEFT HAND GRIP Removal 1. Remove left handlebar switch controls. See 7.31 LEFT HANDLEBAR SWITCH . NOTE If the left hand grip is patterned, align it with the pattern on the right grip with the throttle in the fully closed position. 2. Use a sharp blade to carefully cut rubber and then peel off handlebar. 2.
Immediately push grip completely onto end of handlebar using a twisting motion. Do not hesitate when installing grip or adhesive may dry before installation is complete. 3. Thoroughly clean handlebar to remove all residual adhesive. 3. Let 6-8 hours elapse at 21 °C (70 °F) to allow adhesive to fully cure. 4. Install left handlebar switch controls. See 7.31 LEFT HANDLEBAR SWITCH . 2-52 2009 VRSC Service: Chassis