HOME 2.25 TRUING LACED WHEELS GENERAL The rim must be trued both laterally and radially. If new bear- ings were installed, wheels may be trued with only the bearings and center spacer installed. sm02463 LATERAL TRUING TOOL NAME PART NUMBER SPOKE WRENCH HD-94681-80 WHEEL TRUING STAND HD-99500-80 1. Divide the wheel spokes into ten groups of four and mark the center of each group with a piece of tape. The groups should be directly across from one another and approxim- ately 90 degrees apart. Tighten the spokes in these four groups finger tight. 2. See Figure 2-72 . Install truing arbor in wheel hub and place wheel in WHEEL TRUING STAND (Part No. HD- 99500-80).
Tighten arbor nuts so hub will turn on its bearings. Figure 2-72. Front Wheel Hub Offset Dimension NOTE 3. 4. See Figure 2-74 • measurement. • 5. edge side is less attached to the hub attached to the hub 6. Figure 2-73. Rear Wheel Hub Offset Dimension sc side of the hub can be identified by Table 2-9. Offset Dimensions oves cut into the disc mounting surface. RIM TYPE RIM SIZE IN. MM. ge across primary brake disc mounting d one of the marked spoke groups. Chrome alu- 19 0.890-0.910 22.68-23.19 minum profile and Table 2-9. Measure distance "A" from laced to the location as shown.
NOTES n spoke, one flat at a time, and recheck sm03223 e appropriate spokes before tightening versing this procedure will cause the rim -round. is not correct, tighten the four spokes SPOKE WRENCH (Part No. HD-94681- , If the measurement on the right rim than it should be, loosen the two spokes ub right side and tighten the two spokes ub left side.Turn all four spokes an equal until offset dimension is correct. ous step for all ten groups on the wheel. Table 2-9. Offset Dimensions RIM TYPE RIM SIZE IN. MM. RIM SIZE IN. MM. ps. Chrome alu- minum profile A" from laced echeck sm03223 19 0.890-0.910 22.68-23.19 RADIAL TRUING 1. See Figure 2-75. Adjust truing tire bead seat as shown.
The 0.76 mm (0.030 in.). 2. Spin the rim slowly. If the rim near a marked group of spoke marked group on the opposite e: Chassis stand gauge to the rim's rim should be trued within contacts the gauge on or s, loosen the spokes in the side of the rim. Now tighten