HOME 10. See Figure 2-128 . Remove fork seal driver, reverse tool to short side of tool to prepare to install chrome dust cover. Rotate slider cover to match any removal burrs in slider and tap chrome dust cover into place. sm03154 sm03151 Figure 2-130. Measure Fork Oil NOTE Figure 2-128. Install Chrome Dust Cover Fork oil level is measured from top of fork tube, with spacer and spring removed and fork fully compressed. Measure fork oil level from top of fork tube using the OIL LEVEL GAUGE (Part No. HD-59000B). Table 2-12. Oil Level, Left Fork 14. See Figure 2-130 . Fully compress fork and adjust the oil level to specification from top of fork tube using OIL LEVEL GAUGE (Part No. HD-59000B).
Refer to Table 2-12 . 584 cc 11. Reposition fork assembly to be vertical in vise and fully NOTE sm03152 sm03155 1 2 1. Collar MEASUREMENT 3.4 in. 87 mm 19.7 oz compressed. 12. Fill fork with Harley-Davidson TYPE E FORK OI No. HD-99884-80) until it is approximately 50.8 m in.) from top of fork tube. in this manner. L (Part m (2.0 15. See Figure 2-131. Fully extend fork and install spring in fork tube (with tightly wound end at bottom), proceed to install washer and collar. Figure 2-1 13. See Figure 2-129. Sl exhaust air from ass 2-94 2009 VRSC Servic 2. Spring 29. Pump Cartridge Figure 2-131. Collar and S owly pump cartridge 8 to 10 times to embly. e: Chassis pring Assembly