HOME DISASSEMBLY AND ASSEMBLY sm03191 TOOL NAME PART NUMBER WHEEL BEARING REMOVAL/REPLACEMENT KIT HD-44060-4 SWINGARM BEARING INSTALLATION TOOL HD-47175 NOTES • Remove left pivot bearing assembly from fork only if replacement is required. the complete bearing assembly must be replaced as a unit when replacement is neces- sary. Do not intermix bearing components. • The rear fork has been designed to incorporate a lock ring that MUST be removed before attempting to remove the left-side bearing. Using a small screwdriver or pick, catch the end of lock ring and remove ring from swingarm in a spiral fashion as shown in the following figures. Figure 2-153.
Slowly spiral ring out of groove General T sm03189 s b b he SWINGARM BEARING INSTALLATION TOOL (Part No. HD-47175) is used with parts from WHEEL BEARING REMOVAL/REPLACEMENT KIT (Part No. HD-44060-4) sm03083 2 3 4 1 7 5 6 1. Forcing screw 2. Nice bearing 3. Washer 4. Nut 5. Removal cup 6. Swingarm bearing remover/installer 7. Bushing remover/installer 6. Swingarm bearing remove 7. Bushing remover/installer ocate End of Lock Ring Figure 2-154. Parts Used From H Swingarm Bearing Ins 2009 VRSC 6. Swingarm bearing remove 7. Bushing remover/installer Figure 2-152. L D-44060-4 Kit (1-4) and tallation Tool Service: Chassis 2-107