HOME 3.11 ENGINE BOTTOM END SERVICE CRANKSHAFT, PISTON AND CYLINDER LINER REMOVAL/INSTALLATION bumps toward the water pump side and the front cylinder toward the cam drive side. TOOL NAME PART NUMBER sm01103 FLYWHEEL SUPPORT FIXTURE HD-44358 CYLINDER LINER REMOVER/INSTALLER HD-45313 CRANKSHAFT ASSEMBLY RETAINER HD-45316 PISTON PIN REMOVAL AND INSTALLATION TOOL HD-47189 PISTON RING COMPRESSOR HD-96333-105 TORQUE ANGLE GAUGE SNAP-ON TA360 1. See Figure 3-105 . Install CRANKSHAFT ASSEMBLY RETAINER (Part No. HD-45316). sm01079 Figure 3-107. Match Rod and Cap 3. See Figure 3-107 . Note the numbers on connecting rod and cap. Connecting rods and caps must be used in matched sets. Figure 3-105.
Install Crankshaft Assembly Retainers sm01104 sm01102 Figure 3-106. Connecting Rod Orientation Figure 3-108. Loosen Rod Cap Fasteners 2. See Figure 3-106. Note the casting bumps on the con- 4. See Figure 3-108. Loosen connecting rod caps fasteners. necting rods and caps. The rear cylinder must have the 3-50 2009 VRSC Service: Engine nnecting Rod Orientation Figure 3-108. Loosen Rod ote the casting bumps on the con- 4. See Figure 3-108. Loosen conn ps. The rear cylinder must have the e: Engine Figure 3-106. Co 2. See Figure 3-106. N necting rods and ca 3-50 2009 VRSC Servic Cap Fasteners ecting rod caps fasteners.