2009 — Installation

HOME 4.6 ENGINE COOLANT TEMPERATURE SENSOR (ECT) GENERAL 7. Cover intake openings to prevent objects from falling into intake bore. Remove throttle body and fuel rail. Refer to ELECTRICAL DIAGNOSTIC MANUAL for information on the function and testing of the engine coolant temperature (ECT) sensor. 8. See Figure 4-9 . Unplug ECT sensor connector [90B] by pulling external latch outward and using rocking motion to remove. REMOVAL 9. Loosen ECT sensor using socket. When sensor starts to turn easily, finish removing by hand. INSTALLATION To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b) 1.

Hand start new ECT sensor into thermostat housing 2-3 turns. 1. Remove right side cover and remove maxi-fuse. See 7.4 MAXI-FUSE . 2. Tighten sensor to 23 Nm (17 ft-lbs). 3. Connect ECT sensor connector [90B]. 2. Remove air box assembly. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . 4. Uncover intake openings and throttle body. 5. Orient intake clamps as shown and install throttle body and fuel rail. Tighten clamps 1.25 Nm (11 in-lbs ). 6. Install coils. See 1.22 SPARK PLUGS AND COIL . Cover the throttle body bores with duct tape to prevent objects from falling down the injector bores. Do NOT use shop cloths or objects that could damage the throttle plates. (00212d) 7. Attach fuel lines. a.

Insert fuel lines from injector back under frame and connect to fuel tank. 3. Cover air intakes to prevent debris from entering cylinders. b. Push connector onto fuel tank elbow until a "click" is heard. 4. Remove block drain screw. Drain cooling system. See 5.3 ENGINE COOLANT . 5. Loosen clamps at each intake and lift throttle body straight up. c. Install right angle connectors on rigid lines from injector. Push until audible "click" is heard. 8. Fill engine coolant system with Genuine Harley-Davidson Extended Life Antifreeze & Coolant through the coolant overflow bottle. sm01186 9. Replace the maxi-fuse and right side cover. 10.

After running engine, check coolant level in overflow bottle with coolant cold and motorcycle on jiffy stand. If level is below COLD FULL line, remove cap from overflow bottle and add antifreeze until fluid level reaches COLD FULL line. 11. Continue to run engine, check level, and add antifreeze until coolant level remains at COLD FULL line with the motorcycle on the jiffy stand. Figure 4-8. Intake Clamps,Throttle Body Removed (typical) NOTE Note position of the clamps for reassembly. 6. With throttle cables attached, wrap a shop towel around body for protection and secure away from engine. 2009 VRSC Service: Fuel System 4-9