HOME INSTALLATION 5. Install mufflers (7, 8) one at a time. 6. Install stud plates (18) with fasteners. • Always loosely assemble exhaust system on motorcycle before following tightening procedure. NOTES 7. Tighten the exhaust system as follows: a. Making sure the crossover connection is fully seated, tighten TORCA clamp (10) to 13-15 Nm (115-133 in- lbs ). • When installing mufflers make sure to insert the pins on the mufflers into the isolators in the end of the exhaust support tubes. b. Tighten the top and bottom nut of the front cylinder head exhaust flange (2) to 8-12 Nm (71-106 in-lbs ). • TORCA muffler clamps have eliminated the need for sil- icone or graphite tape during assembly.
To guarantee sealing integrity of muffler clamps, and prevent the possib- ility of leakage, Harley-Davidson recommends that the muffler clamp assemblies be discarded and replaced each time they are removed. c. Tighten the top and bottom nut of the rear cylinder head exhaust flange to 8-12 Nm (71-106 in-lbs ). d. Tighten fasteners on exhaust bracket stud plate to 19-27 Nm (14-20 ft-lbs). 1. See Figure 4-42 . Install front and rear exhaust pipe seals (with the tapered side out). e. Tighten the two TORCA clamps on the mufflers to 52-58 Nm (38-43 ft-lbs). 2. Install rear exhaust pipe (3) to cylinder head. 3. Install new TORCA clamp (10) on rear exhaust pipe crossover (3). 8.
Install heat shields on exhaust pipes. Position each clamp so that screw is on the outboard side in the most access- ible position and then tighten to 2.3-4.5 Nm (20-40 in-lbs ). 4. Install new exhaust seal (25), then twist and push flange on front exhaust crossover (1) into rear exhaust crossover pipe (3). Install front exhaust pipe to cylinder head using new seals (24) and retaining rings (23). 9. Connect front and rear oxygen sensors (14). 10. Install the main fuse and the right side cover. 2009 VRSC Service: Fuel System 4-35