HOME Installation 1. See Figure 4-46 . Position new carbon canister under frame just in front of electrical caddy and install fasteners and tighten. To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) 2. Attach tubes to canister connections as marked. 2. See Figure 4-46 . Press tab on side of electrical caddy and slide purge solenoid (7) free from electrical caddy. 3. Install new EVAP system label on front frame down tube. 3. Disconnect the wire connector to the purge solenoid. TUBE ROUTING/REPLACEMENT 4. Gently pull off the carbon canister to purge solenoid tube (4). NOTE 5.
Gently pull off the purge solenoid to throttle body tube (5). Record location of cable ties before removal. Install cable ties in same location when installing. Installation 1. Slide purge solenoid (7) onto tab on side of electrical caddy until an audible click is heard. Stop the engine when refueling or servicing the fuel system. Do not smoke or allow open flame or sparks near gasoline. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. (00002a) 2. Push on the purge solenoid to throttle body tube (5). 3. Push on the carbon canister to purge solenoid tube (4). 4. Connect wire connector. 5. Replace the maxi-fuse and the right side cover. 1.
Route purge solenoid tubes. a. See Figure 4-46 . Attach the purge solenoid to throttle body tube (5) to the throttle body. CARBON CANISTER Removal/Inspection b. Route purge solenoid to throttle body tube (5) under frame tube to purge solenoid (7). Install cable ties. The EVAP carbon canister is mounted under the frame directly in front of the electrical caddy. It can be accessed from under the rider seat. c. Attach canister to purge solenoid tube (4) to purge solenoid. d. Route canister to purge solenoid tube (4) to the carbon canister (6). Attach tube to the fitting marked CARB (1) on left side of canister. Install cable ties. 1. See Figure 4-46 . Note tube connections.
Gently pull tubes (3, 4, and 5) off carbon canister (6). 2. Remove fasteners (1) and slide carbon canister from under frame. 2. Route fuel tank vapor vent tubes. a. Route fuel tank vent tube (3) as shown. 3. Inspect and replace all tubes, and/or carbon canister as required. b. Attach short segment of tube to the bottom or short end of the vapor valve and to the fitting marked TANK on carbon canister (6). 4-40 2009 VRSC Service: Fuel System