2009 — Disassembly

HOME 5.6 COOLANT PIPES AND HOSES REMOVAL 8. Squeeze clamp (17) and pull off end of overflow hose at overflow bottle. Pull drain hose to radiator/oil cooler off overflow bottle. Remove overflow bottle. TOOL NAME PART NUMBER SCREWDRIVER SNAP-ON SDD1410 9. Loosen clamps (12, 17) on bottom of hoses to water pump and thermostat. 1. Allow cooling system to cool. 2. Remove right side cover and maxi-fuse. See 7.4 MAXI- FUSE . 10. Use a long thin SCREWDRIVER (Part No. Snap-on SDD1410) to loosen clamps (12) and pull hoses (10, 13) off radiator. 11. Remove engine coolant pipes (2, 3) with hoses (10, 13, 15, 18, and 20).

To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) DISASSEMBLY 3. Remove the negative battery cable. 1. See Figure 5-16 . Cut shrink clamps (9) from the coolant inlet and the coolant outlet pipes (2, 3) and hoses (10, 13, 19). NOTE To remove shrink clamps without cutting, use a soldering iron and, carefully, melt a slice through the band without damaging the hose. Do not remove radiator filler cap when engine is hot. The cooling system is under pressure and hot coolant and steam can escape, which could cause severe burns. Allow engine to cool before servicing the cooling system. (00091a) 2.

Loosen overflow hose clamp (17) and remove overflow hose (18) from filler neck. 4. Open seat and remove pressure cap. 3. Remove hose cover (16) and loosen upper clamp (14) from the water pump to coolant inlet pipe hose. 5. Remove left side radiator trim cover. Remove radiator plug and drain engine coolant into suitable container. 4. Clean hose mounting stems on the engine coolant inlet pipe (2) and the engine coolant outlet pipe (3) with a wire brush. 6. Remove air filter top, air filter, breather hose, velocity stacks and air filter bottom. See 1.5 AIR CLEANER AND EXHAUST SYSTEM . 5. Inspect all components and replace as required. 7. See Figure 5-16 . Loosen pipe clamp (4).

Loosen and remove fastener (7) holding p-clamp (8) to engine. 5-14 2009 VRSC Service: Cooling System