2009 — Disassembly - 1st Gear End

HOME 8. To complete input shaft assembly -2nd gear end go to 6.7 INPUT SHAFT, Disassembly - 2nd Gear End . Figure 6-151. 2nd Gear 4. See Figure 6-148. Install half moon keepers. sm00850 Figure 6-149. Splined Thrust Washer 5. See Figure 6-149. Install splined thrust washer, stepped side toward gears. sm00851 Figure 6-150. Bearing and 5th Gear 6. See Figure 6-150. Install lubricated new split cage bearing behind splined thrust washer. Install 5th gear over split cage bearing. NOTE 2nd gear is an interference fit and MUST be replaced when removed from the input shaft, regardless of its condition. 7. See Figure 6-150. Install new 2nd gear. Use a pressing ring to clear the shaft.

Press gear on shaft until it bottoms on the gearset. sm00852 DISASSEMBLY - 1ST GE Bearing Removal - 1st Ge 1. See Figure 6-152. Remove 1st 2009 VRSC Serv AR END ar End gear crankcase bearing. ice: Transmission 6-47