2009 — Operation

HOME 7.6 STARTER SYSTEM GENERAL Wiring Diagrams The starter system is made up of the starter relay, starter solenoid, and starter motor. The starter drive gear engages a geared limiter assembly which engages a starter ring gear whose hub rotates inside a ball clutch on the rotor assembly. See Figure 7-12 . For additional information concerning the starting system circuit, see the wiring diagrams in B.1 CON- NECTORS . Starter Relay The rotation of the starter is transferred to the crankshaft of the engine through the ball clutch. The starter motor torque is multiplied through the gear reduction of the starter drive gear to the limiter assembly gear and to the starter ring gear.

The three gears remain in constant engagement. The starter relay is not repairable. Replace the unit if it fails. Starter The starter is not repairable. Replace the unit if it fails. Figure 7-11. Starter Drive (Left side engine cover/stator removed) 2009 VRSC Service: Electrical 7-9 sm00917 2 3 1 4 1. Starter drive gear 2. Limiter assembly 3. Starter ring gear 4. Rotor The starter solenoid is not repairable. Replace the unit if it fails. OPERATION When the starter switch is pushed, the starter relay is activated which activates the starter solenoid allowing current to flow to the starter motor.

The starter drive gear transfers rotation to the limiter assembly and the limiter assembly gear transfers rotation to the starter ring gear. The starter ring gear drives the alternator rotor on the end of the crankshaft. When the engine starts, a ball clutch on the back side of the rotor disengages allowing the starter ring gear and the rotor to rotate independently of each other. NOTE For troubleshooting and diagnostic information see VRSC ELECTRICAL DIAGNOSTIC MANUAL. 1. Starter drive gear 2. Limiter assembly 3. Starter ring gear 4. Rotor