2009 — Installation

HOME 7.13 TAIL LAMP: ALL EXCEPT VRSCF REMOVAL 1. See Figure 7-23 . Insert a small screwdriver into middle hole of license plate light cover. Push forward with screwdriver to release tail lamp housing retaining clip. sm00990 1 2. Lift rear of tail lamp housing up and slide housing assembly away from fender. 4 3. See Figure 7-24 . To replace tail lamp bulb: a. Turn bulb socket assembly clockwise (CW) and pull outward from tail lamp housing. 5 b. Remove bulb by turning counterclockwise (CCW) and pulling from bulb socket assembly. c. Push new bulb into bulb socket assembly and turn clockwise. 2 d. Insert bulb socket assembly into tail lamp housing and turn counterclockwise to lock in place. 3 4.

To replace license plate bulb: a. Remove license plate bulb by turning housing coun- terclockwise. Tab on bulb housing must clear tab on license plate light housing. 1. Tail lamp connector 2. Tail lamp bulb socket assembly 3. Retaining clip 4. Mounting tabs 5. License plate bulb (2) b. Pull bulb from socket and replace with new bulb. c. Install housing by aligning tabs and turning clockwise. 5. To replace entire tail lamp assembly: a. Press down on release latch on connector socket. Figure 7-24.Tail Lamp Wiring (typical) b. Detach socket from wiring harness connector. INSTALLATION 1. See Figure 7-24. Route all electr sm00988 harnesses to either side of tail away from tail lamp bulb housin 2.

If entire tail lamp assembly wa harness connector in socket and release latch locks in place. NOTE When installing tail lamp assembly, is pointing toward rear of vehicle. 3. Install tail lamp assembly as fol a. Insert tabs on front of tail la edge of fender opening. b. Carefully push tail lamp vehicle. c. Engage retaining clip wi opening. Gently press dow until clip locks in place. NOTE Figure 7-23. Releasing Tail Lamp Retaining Clip: Retaining clip must engage rear fen VRSCAW/VRSCDX to remain locked into position in rea 2009 VRSC 1. See Figure 7-24. Route all electr harnesses to either side of tail away from tail lamp bulb housin 2.

If entire tail lamp assembly wa harness connector in socket and release latch locks in place. NOTE When installing tail lamp assembly, is pointing toward rear of vehicle. 3. Install tail lamp assembly as fol a. Insert tabs on front of tail la edge of fender opening. b. Carefully push tail lamp vehicle. c. Engage retaining clip wi opening. Gently press dow until clip locks in place. NOTE ing Tail Lamp Retaining Clip: Retaining clip must engage rear fen CAW/VRSCDX to remain locked into position in rea 2009 VRSC Figure 7-23. Releas VRS