2009 — Delphi Main Fuse Housing Repair

HOME A.4 DELPHI MAXI-FUSE HOUSING DELPHI MAIN FUSE HOUSING REPAIR General sm00032 A Delphi Main fuse connector completes the circuit through the main fuse. 1 Removing Main Fuse 1. See Figure A-12 . Depress latches on main fuse cover (1) and then slide cover off of connector (2). 2 2. Holding the connector (fuse holder), pull the main fuse out of the connector. Installing Main Fuse 1. Insert the blade terminals of the main fuse into the sockets of the connector and press the main fuse into the con- nector. 2. Slide the cover over the fuse until the cover clicks into place. NOTE If removed from an OE attachment such as a grooved fuse block cover, engage cover and slide into place. 1.

Main fuse cover 2. Delphi main fuse housing Figure A-12. Delphi Connector Housing: Main Fuse Removing Socket Terminals 1. Disconnect battery. See 2. See Figure A-13 3. (4) until it stops. 4. Tug on cable to pull socket from connector housing. Pivot the pick toward the terminal body to release the latch if necessary. 5. Repeat to remove remaining socket terminal. Installing Socket Terminals 1. See Figure A-14 . Carefully bend tang outward away from the terminal body. 2. Properly orient terminal to the cavity in the housing and push terminal into connector housing until it clicks in place. Verify that socket will not back out of chamber. 3. Push rubber seal into connector housing. 4.

Repeat to install remaining socket terminal. 5. Install secondary lock onto connector housing. be sure slots engage tabs on sides of connector housing. 6. Connect battery cables. See 1.9 BATTERY MAINTEN- ANCE . A-8 2009 VRSC Service: Appendix A Connector Repair 1.9 BATTERY MAINTENA NCE. ry lock pening age slots (1) on seconda ove secondary lock. r small screwdriver into o