2009 — Wiring Diagram Information

HOME B.2 WIRING DIAGRAMS Figure B-1. Connector/Wiring Diagram Symbols (typical) WIRING DIAGRAM INFORMATION Wire Color Codes Wire traces on wiring diagrams are labeled with alpha codes. Refer to Table B-2. For Solid Color Wires: See Figure B-1. The alpha code identifies wire color (3). For Striped Wires: The code is written with a slash (/) between the solid color code and the stripe code (4). For example, a trace labeled GN / Y is a green wire with a yellow stripe. Wiring Diagram Symbols See Figure B-1. On wiring diagrams and in service/repair instructions, connectors are identified by a number in brackets (1).

The letter (2) inside the brackets identifies whether the housing is a socket or pin housing. A=Pin: The letter A after a connector number and the pin symbol (6) identifies a pin housing. B=Socket: The letter B after a connector number and the socket symbol (5) identifies a socket housing. Other symbols found on the wiring diagrams include the symbol for a diode (7), a symbol for a wire-to-wire connection (8), a symbol verifying that no connection (9) between two wire traces exists, symbols for actual (10) and virtual (11) splices, and a symbol identifying two wires that are twisted together (12).

Actual splices (10) are splices where two wires are connected together at a specific location along a wire.Virtual splices (11) are splices shown connected anywhere along a wire, usually used in a wiring or schematic diagram for clarity. ed01711 5 3 4 6 1 2 GN/Y TN W 7 [21A] 1 2 4 [21B] 1 2 4 8 W GN/Y TN 1 2 9 12 10 11 1. Connector number 2. Terminal code (A=pin, B=socket) 3. Solid wire color 4. Striped wire color 5. Socket symbol 6. Pin symbol 7. Diode 8. Connection 9. No connection 10. Physical splice 11. Virtual splice 12. Twisted pair TN TN WIRE COLOR Blue Black Brown Green Gray Light Green Orange Pink PK R TN V W Y 2009 VRSC Service: Red Tan Violet White Yellow Appendix B Wiring B-3