HOME sm01738 2 4 16. See Figure 1-68 . Loosen all cam cover fasteners in reverse order of torque sequence. 17. Support engine with jack under oil pan. 18. See Figure 1-68 . Loosen front engine mount bolt and retract jack to allow the engine to drop down approximately 13 mm (1/2 in.). 1 3 NOTE It may be necessary to loosen drive belt, and loosen exhaust at rear support bracket to allow the engine to drop sufficiently. 5 19. Remove fasteners from small cam cover and remove from left side. 20. Remove all remaining fasteners from cam cover. 1. Ground strap 2. Radiator hose P-clamp 3. Front cylinder breather tube 4. Rear cylinder breather tube 5. Cable strap 21. Gently pry up cover and gasket.
Remove cam cover by lifting up and over cam drive sprockets and removing from right side of motorcycle. NOTES • It may be necessary to manipulate or move radiator hoses to allow front cam cover removal. Figure 1-66. Upper Engine • It may be necessary to remove breather hose fitting from rear cam cover to gain additional clearance. Figure 1-67. Cam Cover Torque Sequence 9. See Figure 1-66 throttle body straight up. 10. 11. intake bore. 12. See Figure 1-67 13. 14. 15. frame. sm01839 sm01739 Figure 1-68. Front Engine Mount Bolt osen clamps at each intake and lift up. NOTE e clamps for reassembly. attached, wrap a shop towel around nd secure away from engine.
s to prevent objects from falling into move ground strap at cam cover. retaining radiator hoses. rear (4) breather hoses. Figure 1-69. Correct En ss cable straps (5) along left side of e: Maintenance gine Rotation