Installation EN 1. Install the light bar With the light area facing downwards, atach the power contact points on the light bar to those on the base. Place the base on the upper center of the monitor, and make sure the clamp is firmly secured on the monitor and the botom of the base is against the back of the monitor. Notes: 0-32mm 40° This product is compatible with monitors that are no more than 32 mm in thickness, as well as hairtail monitors, curved monitors, and iMacs. Monitors that are less than 10mm in thickness can support the light bar, but the botom of the base cannot be against the monitor. The angle of the gravity shaf on the base can be adjusted by 40°. Do not pull it too hard.
12 This product cannot be used with laptops.