Instru ction Manual of Lifan Sedan LIFAN Instru ction Manual of Lifan Sedan Instru ction Manual of Lifan Sedan LIFAN 620 620 Air Bag for Driver and Front Passenger System Component Air Bag Warning Lamp ● Abnormali ty or activ atio n of the front safety belt pretensioner will cause the front safety belt not to be retracted or pulled out. play only when working with well-fastened safety belt.
Therefore, for your and your family s safety, pay extra attention to Note and Friendly Tips in this part 2 The warning lamp system is to monitor the air bag ECU, fro nt seat safety belt pretensioner assembly, air charging device, warning lamp, wirin g and power supply (See Section 1-5 “ Maintenance Indicator and Warning Buzzer ” for detail ). ' “ ” “ ” . SRS Note 8 60 40 ● Use safety belt at all times when driving ! 1 3 4 Note ● Keep the right sitting posture , in this case , the safety belt and air bag system can bring their largest protective play! SRS air bag system includes the following assemblies , whose positions are shown in the above figure.
The air bag system, monitored by ECU, has a self-diagnostic function . It indicates the system status through the warning lamp on the instrument panel: The following situations indicate that the air bag system has troubles or has been closed . ● Warning lamp can not light up when tu rning on the ignition switch. Inspect and repair the vehicle at service station at once in case of the following situations . Lifan Air bag system is a supplemental restraint system ( SRS ), which is a supplement to the seat belt . The system can provide an additional protection for the head and chest of driver and passenger in a frontal crash and reduce injury and death.
● Rear seat is much safer for child under 12 years old! 1. SRS warning lamp 2. Front pas senge r air bag assembly (air bag and air charging dev ice) ● After the ignition switch is turned on , the air bag warni ng lamp lights up for about 5 s , and then goes out . In this case , the syst e m is normal. ● Warning lamp can not go out after 5 s or twinkles again and lights up after going out when turning on the ignition switch . ● An accident in the front par t of the vehicle (shaded por tion in the figur e) does not make the front safety bel t pretens ione r wor k . ● Installation and removal of air bag component without permission are not allowed ! 3.
Driver air bag assembly (air bag and air charging device) ● If the air bag has been closed by station , warning lamp will be always on when turning on the ignition switch , which means this system provides no protection at this moment . ● Front saf ety bel t pretensi oner assem bly or its sur roundi ng par t is scr atched , spl i t or dam aged due to other reasons . The air bag system can not take place of the safety belt, for it is just a part of the whole passive safety protection system in vehicle. Additionally , please be noted that the air bag syste m brings into its largest protective 4.
Air bag ECU (Electronic Control Unit) Lifan service ● The warning lamp will light up again afte r the igniti on switc h is closed. It consists of a safety sensor and safety air bag sensor . ● Warning lamp twinkles or lights up when driving . 45 46 Chongqing Lifan Passenger Vehicle Co ., Ltd . Chongqing Lifan Passenger Vehicle Co ., Ltd .