620 Instru ction Manual of Lifan Sedan LIFAN (d)Too low oil pressure war ning lamp (e) OBD system (On-Board Diagnostic System) If any of the following circumstances occurs, it means the part monitored by the warning lamp The lamp is used to warn for over low fault indicator is at fault. It is necessary to send the car to the oil pressure. The indicator lights up when a fault occurs in the Lifan service station for check. If the lamp flic kers or contin ues to ill uminate OBD system of engine.
●When the ignition key is turne d to “ON” in driving, it is necessary to stop the car at a When it illuminates, it is necessary to contact position, the lamp is out or conti nues safe place and stop the engine immediately. the Lifan service station for check and repair to illuminate. Contact the Lifa n service statio n for help. as soon as possible. ●The lamp illuminates in driving. When the engine idles, the lamp may (f)“ABS”warning lamp Durin g the operation, the fact that the flicker now and then or it illuminates for a When the ignition key is turned to “ON”position, warning lamp illuminates for a short while short while after an emergency brake.
the“ABS”warning lamp will illuminate for doesn't mean any problem. During the gradual acceleration of engine, about 3s. After that, if the system goes wrong, if the lamp is out, it is normal. the lamp will continue to illuminate. Warning The oil level should be within the top When the “ABS”warning lamp illuminates While the warni ng lamp of brak e sys tem is and bottom limitation of oil dip rod. (the warning lamp of brake system is out), the illuminating and the “ABS”warni ng lamp ABS system doesn't work, but the brake system illuminates as well, stop the car at a works normally. safe place immediatel y and contact the Warning When the “ABS”warning lamp illuminates Lifan service stati on .
No driving when the warning lamp illu minates, (the warning lamp of brake system is out), Under such circumstance, when a braking is even if just a short distance, or else the engine the wheel may be blocked since the ABS made, the ABS doesn't serve, moreover, the will be damaged. system doesn't work when an emergency brake car is extre mely unstable as well. is made or braking on slippery road. 69 (g)Door ajar warning lamp ●The lamp illuminates or flickers during (k) Insufficient fuel warning The lamp keeps illuminating, till all doors driving. Please fill fuel as soon as possible. close completely.
(i)Reverse radar indication (I) BCM warning lamp (h)“SRS”warning lamp When the key is at “ON”position, the When the probe of reverse radar is at fault, gear lever is at reverse (R) position, the lamp illuminates. A special code reader When the ignition key is turned to “ON”position, when the distance between the car tail is needed for reading out trouble code for the lamp will illuminate for about 5s, which and the barrier is less than 1.5m, the diagnosis. indicates that the air bag and front safety belt indication illuminates and sounds. pretensioner work normally.
(m) SVS warning (j) Temperature warning lamp of The warning lamp system is used to monitor It will illuminate in case of fault occurs the air bag ECU, safety belt prete nsioner engine coolant in engine (OBD excluded). A special assembly, air charging device, warning lamp, code reader is needed for reading out This lamp is used to warn for the too high connection and power supply. trouble code for diagnosis. temperature of engine coolant. if the lamp If any of the following circumstances occurs, flickers or keeps illuminating during driving, it means the part monitored by the warning it is necessary to stop the car at a safe place lamp is at fault or closed down.
It is and stop the engine immediately. necessary to contact the sales service store Check the quantity of engine coolant and or the special repair station of Lifan for refill; meanwhile, check the working state check. of electronic fan. ●When the ignition key is turned to ”On”position, the lamp is out or continues to illumi nate. 70 Chongqing Lifan Passenger Vehicle Co., Ltd.