Lifan — 页 26

Instru ction Manual of Lifan Sedan LIFAN Instru ction Manual of Lifan Sedan Instru ction Manual of Lifan Sedan LIFAN 620 620 CD Disk Exit Press to get the CD disk out and it will return to the radio or USB mode before CD playing automatically. If the CD is not taken out after 10s, then the disk will go inside automatically , however , the player will not play automatically , SRC is to be pressed for switching over . USB Play Resetting Operation When the USB equipment is connected, the system switches to the USB play mode automatically, “ USB ” is displayed ; if the USB equipment is not connected , “ NO USB ” is displayed . If there is USB equipment connected , press SRC to select USB play .

When the USB file list is finished , the player will repeat from the beginning automatically . When such faults as crash, open failure, shutdown or enter failure and disk out occur in using , long press SEL for more than 5 s to make system enter resetting operation . Note ● Never take apart or refit the stereo by yourself. ● Please adjust the sound volume to the degree that may not disturb your hearing the traffic signals ( siren , alarm whistle etc .). CD Disk Maintenance ● Don ' t leave any finger print on the disk Common Fault and Troubleshooting Reverse gear indication ● After the CD exits, put it into CD case, to avoid damage and dust taint.

● Prevent from heat or insolation When CD player is on, pull the gear lever to reverse (R), the CD player enters pause / muse automatically , meanwhile , the “ TEL CALL ” is displayed , indicating the driver that the car is under reverse . ● When handing the disk, take by its central and outer part 83 84 Chongqing Lifan Passenger Vehicle Co ., Ltd . Chongqing Lifan Passenger Vehicle Co ., Ltd .

Fault Cause Troubleshooting The needed radio station can't be searched Weak station signal Switch to manual search Play failure Tainted disk Clean the disk The disk inserte d is not among the kinds available for play Check the disk kind No sound Wrong connection Check the connection The disk is in the drive, but there is no sound The disk is inserted with the wrong side upward Insert the disk with the label side upward Tainted or scratched disk Clean the disk Sound jump, poor tonal quality Tainted or scratched disk Clean the disk The disk can't be taken out Defected disk or failed machine Press (exit). If it still can not work normally, please contact the Lifan service station for repair.

Fault Cause Troubleshooting Host machine is in malfunction, no display Wrong wiring Correct the wiring Fuse blown Repl ace a fuse of the sam e speci ficat ion Host machine is in operation, but the sound is low or there is no sound at all. The volume is turned down too much Turn up the volume Poor radio reception Antenna is not connected properly Check the antenna, and connect it well No sound for left and right tracks Balance of one side is closed Wrong cable connection Adjust the balance/fader mode well accordingly Correct the connection