Instru ction Manual of Lifan Sedan LIFAN Instru ction Manual of Lifan Sedan Instru ction Manual of Lifan Sedan LIFAN Anti-corrosive on Vehicle Body 620 620 Vehicle Cleaning and Waxing A corre ct maintenance of the vehicle can protect it fro m corro sion for long . Most common causes for vehicle corrosion : ●The underside of vehicle is covered with salt and alkali, dust and moisture. ● Protective paint cover scratched by a light collision or stone and grit. It is essential to take an extra care in case of living in a special region or operating the vehicle under special environment . ● The salt and alkali or dust with chemical materials on the road will accelerate the corrosion.
Even in the coastal area or industrial pollution region, there is still salinity in the air. ●A high humidity will accelerate the corrosion, especially in case of a temperature barely above zero . ●A cer tain par t of the veh icle bei ng wet or dam p for a long time will be cor roded, although other par ts kee p dry . ● A high room temperature will cause corrosion to the vehicle components which can not get dry fast due to the lack of correct ventilation. The above shows that it is very important to keep the vehicle clean as much as possible, especially the bottom of the vehicle body, and repair the damaged paint and protection layers as soon as possible.
Follow the rules below to prevent LF620 from corrosion : Always clean the vehicle: A regular cleaning may keep the vehicle body clean. Please abide by the following rules to avoid corrosion. ●High-pressure or steam is very effective for cleaning the chassis and wheel cover. It is hard to see all the slurry and dirt in those two places. Therefore, an extra attention must be paid. It will cause more serious danger in case of only roughly moistening but not cleaning the slurry and chips. The drain holes of door lower brim , doorsill plate and the vehicle frame must not be obstructed by dust ; otherwise the seeper in those parts will cause corrosion ; ● Completely clean the chassis after winter.
Check the inner vehicle compartment: The moisture and dust covering the floor mat will cause corrosion. Please always check the place under the mat and make sure it is dry. Take an extra care during the transportation of chemicals, cleanser, fertilizer, salt and other materials which should be transported by proper containers. In case of any spill or leakage , please immediately clean and keep it dry . Cleaning Lf620 Note Clean the car in normal way. The following cases will cause the paint layer to fall off or result in corrosion to the vehicle body and components. Please immediately clean the vehicle and repair that .
● Driving in the coastal region Be careful not to hurt your hands when cleaning the underside of the floor or the chassis. 1. Wash away the loose dirt by a water pipe, and wash away all the slurry on the vehicle bottom and depressed part of the wheel or the salt and alkali on the road . ● Driving on the road covered with antifreeze. ● Stuck by coal tar, resin, ornithocopros and dead insects ● Driving in a region with a great deal of soot, coal ash, dust, scrap iron or chemical materials Application of mudguard: The mudguard can protect the vehicle in case of driving in salty and alkali region or on gravel roads. It is better if the mudguard is bigger and closer to the ground .
The wheel house mudguard for LF 620 is optionally installed . This installation service is available at the service station . Lifan Warning Do not install the seriously damaged plastic wheel trims ; otherwise , the wheel trims will fly off the wheel and cause an accident during driving . Refer to “ Vehicle Cleaning and Waxing ” for more details . ●Clean the running part of the vehicle at least once each month to avoid corrosion in case of driving on the road with salt and alkali in winter or at coastal areas . Check the paint and trims : In case of any fragment or crack on the paint layer, please immediately go to the station for repair to prevent corrosion .
In case of fragment or crack falling off the metal surface , please go to the station for repair. Park the vehicle in a fully-ventilated garage or a place with roof. Do not park it in a damp and airproof garage. The garage will become damp due to cleaning vehicle in it or the vehicle driving through a seeper or snow road, resulting in corrosion . Although the garage is very dry , bad ventilation will also cause corrosion to a damp vehicle . ● Being evidently dirtied by dust and slurry Lifan service Manual cleaning of LF620 2. Clean the vehicle with neutral cleaning solution. The mixture of cleaning solutions should be carried out according to the instructions of the manufacturer .
Dip a soft cloth with cleaning solution and wipe away the dirt by suds and clean water. Do not wipe it forcefully. Clean the vehicle after its body feels not hot in a shady place. Lifan service 137 138 Chongqing Lifan Passenger Vehicle Co ., Ltd . Chongqing Lifan Passenger Vehicle Co ., Ltd .