Lifan — 页 29

Instru ction Manual of Lifan Sedan LIFAN Instru ction Manual of Lifan Sedan Instru ction Manual of Lifan Sedan LIFAN 620 620 Check the oil level Check the engine coolant level Low level High level Note Note When the engine is under cooling state , check the coolant level in the reservoir, if it is between the marking lines of “ FULL ” and “ LOW ”, it conforms to the requirements. If the oil level is on the low side, it is necessary to fill coolant. (For the type of engine coolant , refer to the “ selection of coolant type ” below .) Warning Warning Noted that not drop any oil on the components of the car. ● Avoid overfilling, or the engine will be damaged .

To avoid burns, when the engine is at hot condition, don ' t take off the radiator cap. It is necessary to obtain enough coolant for the cooling system to ensure the normal operation of engine , or “ boiling ” of car will occur . Whe n the engine is working under overheated condition , the service life will be affected , so much as resulting in bad accidents like engine scraping . ● When the filling is finished, recheck the oil level on the oil rule. If the oil level is below or just a little above the low level, it is necessary to fill the oil of the same type.

● Insufficient oil will cause under-pressure of engine oil, resulting in poor lubrication, bringing about intensified wear and poor cooling of engine, causing frequent troubles and affecting the service life of engine. Selection of coolant type To fill Correct Overfilled Take off the oil filler cap, fill small quantities of oil every time and check the oil rule. The coolant level in the reservoir will change along with the temperature variation, however, if the level is at or below the “ LOW ” line , it is necessary to fill coolant , to make the level reach the “ FULL ” line .

Only use the coolant designated by Lifan, it is necessary to fill proper type of coolant into the cooling system as per the ambient temperature. When the engine is under working temperature, shut down the engine, check the oil level with oil rule. When the oil level reaches the right range, put on the filler cap and screw it down. After filling coolant, if the level of coolant declines within a short time, then some leakage exists in the system. It is necessary to check the radiator, hose, radiator cap, drain plug and water pump. Note 1.

To obtain correct reading, it is necessary to park the car at flat ground, shut down the engine and wait for several minutes, let the oil gather at the bottom of engine. 2. Pull out the oil rule and clean its end . Don ' t just use clean water. Use of improper coolant will damage the cooling system of engine . If no leakage is found, it is necessary to test the cap pressure and check whether there is any leakage at the . For details, contact the service station . Lifan 3. Insert the oil rule again, and try to stick it to the bottom, or else the reading is inaccurate. 4. Pull out the oil rule and check the oil level. Lifan service station 157 158 Chongqing Lifan Passenger Vehicle Co ., Ltd .

Chongqing Lifan Passenger Vehicle Co ., Ltd .