5D2-26 TRANSFER CASE - TOD 6. Compare memorized specification with the checked record. If not matched, perform a coding. 7. Read again memorized coding specification in TOD control unit for confirmation of coding. 8. Check coding specification whether it matches with vehicle or not. If not, perform a coding again. Eliminate the Memorized Fault Code When diagnose by SCANNER, it is required that you make adequate service on defects against all fault codes. And then you should delete the memorized fault codes in TOD control unit using SCANNER as follows; 1. Connect SCANNER with diagnosis connector. 2. Ignition turns “ON”. 3. Select “Vehicle Type” and press “ENTER” key. 4.
Select “Model Type” and press “ENTER” key. 5. Select “Control System” and then select “06 Transfer Case (TOD)”. Press “ENTER” key. YAD5D160 6. When system confirmation screen displays, press “ENTER” key. 7. If there is any fault in the system, it displays as shown. YAD5D170 8. Press the function key “F2”. 9. Press “Yes”. 10. If the memorized fault code is cleared successfully, it appears on the screen as following; “Self Diagnosis Result is Normal”. YAD5D180 SSANGYONG Y200