86 F2B ENGINE T RAKKER E URO 4/5 PRINT603.93. 641/A Figure 156 47579 Fit Tighten the inner screws (1) to 140 Nm torque by means of a torque wrench (3), then with two further angular phases 60 + 60 , using tool 99395216 (4). Tighten again the outer screws (1, Figure 155) with 90 angular closing, using tool 99395215 (3, Figure 155). Fit Base q November 2006 Print 603.93.641/A Revi - June 2007 Figure 154 49022 t the lower crankcase by means of a suitable hoist and ooks (1). Figure 155 47581 OTE Use new screws whenever removing th e bed-plate.
t the lower crankcase and use a torque wrench (2) to ghten the outer screws (1) to 25 Nm according to the agrams on the following page.