Iveco — 603.93.641-3Cp

F3B ENGINE 221 T RAKKER E URO 4/5  1) 2) 3) - - Print 603.93.641 Base q November 2006 Figure 210 71778 hen the adjustment with the slots (1) is not enough to keup the phasedifferenceand the camshaft turns because ecomes integralwith the gear (2); as a result,the reference ue of the cam lift varies, in this situation it is necessary to ceed as follows: lock the screws (2, Figure 209) and turn the engine flywheel clockwise by approx. 1/2 turn; turn the flywheel anticlockwise until the dial gauge gives a reading of the lift of the cam of the camshaft of 5.33 0.05 mm; take out the screws (2, Figure 209) and remove the gear (2) from the camshaft.

Figure 211 77259 rn the flywheel (4) again to bring about the following nditions: a notch (5) can be seen through the inspection window; the tool 99360612 (1) inserted in the hole (3) in the flywheel (4) through the seat (2) of the engine speed sensor. Mount the gear (2, Figure 210) with the 4 slots (1, Figure 210) centred with the fixing holes of the camshaft, locking the relevant screws to therequired tightening torque. Check the timing of the shaft by first turning the flywheel clockwise to dischargethe cam completely and then turn the flywheel anticlockwise until the dial gauge gives a reading of 5.33 0.05 mm. Check the timing conditions described in Figure 208.

Phonic wheel timing Figure 212 77260 Turn the crankshaft by taking the piston of cylinder no. 1 into the compression phase at T.D.C.; turn the flywheel in the opposite direction to the normal direction of rotation by approximately 1/4 of a turn. Again turn the flywheel in its normal direction of rotation until you see the hole marked with the double notch (4) through the inspection hole under the flywheel housing. Insert tool 99360612 (5) into the seat of the flywheel sensor (6). Insert thetool 99360613 (2), via the seat ofthe phasesensor, onto the tooth ( ) obtained on the phonic wheel.

Should inserting thetool (2) prove difficult, loosen thescrews (3) and adjust the phonic wheel (1) appropriately so that the tool (2) gets positionedon thetooth correctly.Goahead and tighten the screws (3).