Iveco — 603.93.641-3Cp

224 F3B ENGINE T RAKKER E URO 4/5 PRINT603.93. 641  Base q November 2006 Print 603.93.641 N A ge M 99 sy 99 By dir po N N N Figure 219 106224 OTE In the case of engines with climate control system compressor spring driving belt, for mounting the belt, tool 99360192 (4) must be used. Different methods may cause tensions impairing spring belt. pply tool 99360321 (2) provided with spacer 99360325 to ars box (1). ount spring belt (3) on driving shaft pulley, mount chock 360192 (4) on compressor pulley (5) for climate control stem. Position spring belt (3) in the opening of tool 360192 marked with kcursor 10/13y.

tool 99360321 (2), rotate driving shaft according to the ection of the arrow ( ) until spring belt (3) is correctly sitioned on compressor pulley (5). OTE While operating, keep tool 99360192 (4) in contact to pulley and at the same time guide spring belt (3) in order to prevent it from twisting. NOTE Belt tensioner is of automatic type ; therefore, further adjusting is not provided after mounting. - refuel engine with provided oil quantity; - dismount engine from rotary stand and take off brackets (99361036) securing the engine. Mount: - oil pressure regulation valve; - engine left support; - air compressor complete with hydraulic guide pump; - sound deadening guard; - pipes.

- if present, climate control system compressor driving belt similarly to belt (1, Figure 217); OTE Spring belt must be replaced by a new one after every dismounting operation. OTE Replacing spring belt with engine on the vehicle is from engine opening after tilting the cab.