F3B ENGINE 235 T RAKKER E URO 4/5 PRINT603.93. 641 Print 603.93.641 Base q November 2006 543210 Electromagnetic fan drive Figure 234 77469 ELECTROMAGNETIC FAN DRIVE SECTION Using a feeler gauge, check the gap between the anchor assembly (2) and the pulley (1), it must be no greater than 2.5 mm. The electro-magnetic fan drive action depends on: - the coolant temperature; - the climate control system fluid pressure (if any); - the slowing down action of the intarder on (if any). Idling condition:
- water temperature is less than 93 C and both the Intarder _ and the air-conditioning unit (where available) are OFF; - coolant temperature is less than 85 C and the _ air-conditioning system is ON (pressure inside the circuit is less than 18 bar); - coolant temperature is less than 85 C, and the Intarder is _ ON, with its braking power less than 41% of its maximum power. The first speed is actuated when: - coolant temperature reaches 85 C, and the Intarder is _ ON, with its braking power greater than 41% of its maximum power; - coolant temperature reaches 85 C and the _ air-conditioning system is ON (pressure inside the circuit in higher than 18 bar); The second speed is actuated when:
- coolant temperature reaches 93 C, and the Intarder is _ either OFF or ON with its braking power less than 41% (speed is deactuated when temperature falls down to 88 C); _ - coolant temperature reaches 85%, the Intarder is ON (with its braking power greaterthan 41%of its maximumpower), or the air-conditioning system is ON and the pressure inside the circuit is 22 bar. When second speed actuation is required, the system will drive the fan for 5 seconds at the first speed and then engages the second speed. This will increase belt and fan component wear in time.
When the fan first speed is actuated for more than 1 minute, the system actuates the second speed until the control parameters fall under the operation levels. As to the description ofthe electro-magnetic fan driveopera- tion and servicing,seethe kManual for electric/electronic sys- tem repairingy - Volume 3 543210 Water pump Figure 235 60631 CROSS-SECTION OF THE WATER PUMP The water pump is composed of: impeller, bearing, seal and driving pulley. NOTE Check that the pump body has no cracks or water leakage; if it does, replace the entire water pump.
543250 Thermostat View of thermostat operation Figure 236 TO THE EXPANSION TUB FROM TO THE THE ENGINE BY PASS Water circulating in the engine 60747 Figure 237 TO THE RADIATOR TO THE EXPANSION TUB TO THE BY PASS FROM THE ENGINE 60748 Water leaving the thermostat Check the thermostat works properly; replace it if in doubt. Temperature of start of travel 84 C 2 C. Minimum travel 15 mm at 94 C 2 C.