290 DIAGNOSIS T RAKKER E URO 4/5 (Continue) Base q November 2006 Print 603.93.641 Visible Failure Possible cause Repair action Engine lacks power Fuel circuit inefficient. Check if the mesh filter in the tank, the fuel pre-filter and filter are clogged; in this case change them. Check if the 0,3 bar valve on the fuel re- turn is blocked in open position (low pressure) or in closed position (high temperature), and then replace it. Check possible circuit leaks and the fuel pump efficiency. Injectors inefficient. Seizure of the plunger of one of the in- jectors may occur or fuel may leak through the O - Ring.
Carry out the Engine Test and proceed according to the instructions displayed. Engine air suction circuit inefficient. Remove circuit necks and replace the air filter if clogged. Check the cartridge clogging indicator. Exhaust gas circuit inefficient. Eliminate exhaust manifold leaks. Working temperature not correct. Check cooling system. VGT actuator inefficient. Carry out the Engine Test on the basis of the instructions displayed by the diag- nosis instrument. Turbo-compressor inefficient. Carry out the Engine Test on the tur- bine and check integrity of the following turbo-compressor components:
- rotating blades; - bearings; - modulating valve; - VGT filter clogged; - turbine actuator; Change faulty component. Engine Test with Modus q IT2000 q E.A.SY.. Injection mechanical system inefficient. Check wear of the injector rocker arms, the roller, the rocker arm bushes and the camshaft tappets. Valve clearance inefficient. Adjust valve clearance.