Iveco — 603.93.641-3Cp

6 T RAKKER E URO 4/5 CLUTCH TROUBLESHOOTING  For any actuator operation failure, on vehicles fitted with EuroTronic transmission, see the related transmission diagnosis. NOTE (Continue) Base - November 2006 Print 603.93.641 Visible Failure Possible cause Repair action Noise when clutch pedal is depressed Thrust bearing excessively worn, dam- aged or not properly lubricated. Replace thrust bearing. Excessive play between the splines on the transmission input shaft and the relative housing in driven plate hub. Replace the shaft and also the driven plate if necessary. Noise when the pedal is released Springs of driven plate broken or weak. Replace driven plate.

Transmission input shaft worn. Replace the shaft and also the driven plate if necessary. Thrust bearing has play in engagement sleeve. Replace the thrust bearing. The clutch snatches Oil or grease on engine flywheel or on driven plate linings Eliminate the problem causing the con- tamination; clean flywheel thoroughly then replace driven plate. Pressure plate distorted. Replace the clutch. Uneven wear of friction linings due to run-out of driven plate. Replace the driven plate. Diaphragm spring weak or fingers broken. Replace the driven plate. The clutch does not disengage Oil or grease on driven plate linings. Replace the shaft and also the driven plate if necessary.

Transmission input spline damaged thus preventing driven plate from sliding. Check and adjust the stroke of the oper- ator cylinder with no load. Air in the hydraulic circuit (vehicles with EuroTronic transmission excluded). Bleed the circuit. The clutch slips Driven plate linings worn or burnt. Replace the driven plate. Diaphragm spring weak or fingers broken. Replace the clutch. Oil or grease on driven plate linings. Eliminate the problem causing the contamination and replace driven plate