GEARBOXES ZF 16 S 1620 T.D. - 2220 T.D. - 2520 T.O. 15 T RAKKER E URO 4/5 DESCRIPTION PRINT603. 93.641 The ZF 16 S 1620 / 1920 / 2220 gearboxes in the T.D. (direct drive) or T.O. (overdrive) versions are composed of: These gearboxes therefore have sixteen forward speeds with finely staggered ratios that can be engaged in succession and two reverse gears. - A central box containing the main shaft, input shaft, layshaft and thegears for thefour forward speeds and one reverse gear. The synchronizing devices are the single-cone type. - A rear box containing the Epicyclic Reduction Gear Unit Lubrication is made with a gear pump. (ERG).
Its function is to double the number of forward speeds by using epicyclic gears with helical toothing. This produces a range of gears that, starting with the four incoming speeds, makes it possible to have eight different ratios at the output (four normal speeds plus four reduced speeds). The double-H speed control is fitted with an air -operated yservoshifty device to improve speed selection and engagement. The servoshift is a device comprising a mechanical/pneumatic module and a double-acting cylinder. The advantages of this device are:
- A front box containing the step-up gearing, called the ysplittery, that makes it possible for each of the eight forward speeds and for the reverse gear to obtain an additional double selection. The ysplittery therefore halves the stagger between two successive ratios and each gear is divided into a slow ratio (L = slow ratio) and a fast ratio (S = fast ratio). - Faster speed selection and engagement with less effort. - It cushions the vibrations of the control linkage, reducing - Less synchronizing device stress. noise. The device works mechanically if the pneumatic system breaks down. Figure 1 71107 Base - November 2006 Print 603.93.641