Iveco — 603.93.641-3Cp

20/5 T RAKKER E URO 4/5 GEARBOXES ZF 16 S 1620 T.D. - 2220 T.D. - 2520 T.O. GEARBOX FAULT DIAGNOSIS Principal operational anomalies:  Print 603.93.641/A Revi - June 2007 Visible Failure Possible cause Repair action NOISE Excessive clearance between gears. Overhaul the gearbox and replace worn gears. Gears, bearings, synchronizer rings and connecting parts worn. Replace worn parts. Insufficient lubricating oil level in the gearbox. Top up to correct level with Tutela ZC 90 or Tutela Truck Fe-Gear oil. GEARS DISENGAGE SPONTANEOUSLY AND ENGAGE INCORRECTLY Gears not properly engaged. Fully engage gears before releasing clutch pedal. Gearshift forks broken.

Remove transmission, overhaul and replace parts as necessary. Synchroniser rings worn Inspect gears and sliding sleeves for gear engagement, replacing any which are damaged; replace synchroniser rings Defective operation ofepicyclicreduction gear Inspect and replace damaged parts GEARS DIFFICULT AND STIFF TO ENGAGE Forks stiff on rods Dismantle the transmission and look for the cause of the stiffness; repair as necessary Movement of sliding sleeves obstructed Inspect and repair as necessary Transmission filled with unsuitable fluid. Drain theoil and refill with Tutela ZC 90 or Tutela Truck Fe-Gear oil Clutch not disengaging Adjust control or replace.

PNEUMATIC CONTROL SYSTEM DEFECTIVE OR INEFFICIENT * Defective air pipe connections Check the connections and restore them if necessary. Air pipe bent and/or crushed Replace the pipe Air leaks from the pipe. Check there are no leaks in the pipes and fittings; use an acoustic appliance or soapy water. Replace or tighten the seal if necessary. Air leaks from the pressure reduction valve. Replace the valve or its seals. Defective pressure reduction valve setting. Check the valve pressure. Replace if necessary. Air leaks from the inhibitor valves . Inhibitor valves do not work. Check the inhibitor valves. If necessary, replace the valves or their seals. Air leaks from the driving cylinders.

Replacethegaskets and seals ofthe driving cylinders. * The checks have to be made with the engine switched off and the air tanks full.