Iveco — 603.93.641-3Cp

21 GEARBOXESZF 16 S 1620 T.D. - 2220 T.D. - 2520 T.O. T RAKKER E URO 4/5  PRINT603.93. 641 530210 REMOVING-REFITTING THE GEARBOX Removal Figure 4 To remove the gearbox, proceed as follows: - Set the vehicle over a pit or on a lift. - Disconnect the battery cables to pr event any short-circuiting. - Disconnect thecable (11)using the connectors ( ) and breaking the safety lead off the screw (10). - Disconnect the connector (7) and the pipe (8) from the power take-off (if applicable). - Disconnect the air pipes (4) and (5). - Free the pipes (6) from the clamps (12). - Undoing the fasteners (13), disconnect the tie rod (14) from the gearbox.

- Loosen the screw (2) and extract the lever (3) together with the tie rod (1) from the gearbox after marking its position for reassembly. - Remove thefasteners (15) of thegearboxbell,accessible from above. NOTE For gearboxes with the intarder, proceed as follows: - Drain off the engine coolant and disconnect the - If the cross member of the chassis fr ame pipes from the heat exchanger. prevents you from removing the gearbox, you need to drain off the oil from the intarder; take out the nuts and screws fixing the heat exchanger to the intarder, remove the stud bolts and detach the heat exchanger. 71751 Base - November 2006 Print 603.93.641