22/5 T RAKKER E URO 4/5 GEARBOXESZF 16 S 1620 T.D. - 2220 T.D. - 2520 T.O. 61257 (2). new gasket. 61227 distributor (4), screwing 61226 (1) and (5), in the position Print 603.93.641/A Revi - June 2007 Figure 6/21 Fit a new ring (1) on the piston (2) securing it with the circlip (3). Figure 6/22 Figure 6/24 61230 and fit this in the box, Position the push rod (3) with th Refit the servoshift (1) with a new Figure 6/25 61229 gasket. n them to the required Screw down the screws (1) and tig torque. Connect the air pipe (3) to the down the fitting (2) with new cop it to the required torque. Refitting Figure 6/26 43812 g:
13) with a new seal; 1 and 9) with the new in the position marked Refit the gearbox (5), screw dow ut (5) to the required tighten them to the required torq Connect the pipes (3 and 4) to t o the specified torque. found at removal, with the fittings ( new washers. Insert the pin (3) in the box. Put the top cover (2) on with a new Screw down the screws (1) and tighte torque. Figure 6/23 Complete gearbox assembly by fittin - push rod (11), spring (12), plug ( - push rods (2 and 10), switches ( washers; - cup (8), lever (7) on the rod (6) during removal and tighten the n torque. - valve (3) and tighten screws (4) t