SAFETY AND IMPORTANT WARNING ITEMS 2. CHECKPOINTS WHEN PERFORMING ON-SITE SERVICE HP MFP's are extensively tested before shipping, to ensure that all applicable safety standards are met, in order to pro- tect the customer and customer engineer (hereafter called the CE) from the risk of injury. However, in daily use, any electri-cal equipment may be subject to parts wear and eventual failure. In order to maintain safety and reliability, the CE mustperform regular safety checks. 2.1 Power Supply WARNING: Wall Outlet • Check that main voltage is as specified. Plug the power cord into the dedi- cated wall outlet with a capacity greater than the maximum power consump- tion.
If excessive current flows in the wall outlet, fire may result. kw • If two or more power cords can be plugged into the wall outlet, the total load must not exceed the rating of the wall outlet. If excessive current flows in the wall outlet, fire may result. WARNING: Power Plug and Cord • Make sure the power cord is plugged in the wall outlet securely. Contact problems may lead to increased resistance, overheating, and the risk of fire. • Check whether the power cord is damaged. Check whether the sheath is damaged. If the power plug, cord, or sheath is damaged, replace with a new power cord (with plugs on both ends) specified by hp.
Using the damaged power cord may result in fire or electric shock. • When using the power cord (inlet type) that came with this MFP, be sure to observe the following precautions: a. on the rear panel of the MFP. Make sure the MFP-side power plug is securely inserted in the socket Secure the cord with a fixture properly. b. If the power cord or sheath is damaged, replace with a new power cord If the power cord (inlet type) is not connected to the MFP securely, a (with plugs on both ends) specified by hp. contact problem may lead to increased resistance, overheating, and risk of fire. • Check whether the power cord is not stepped on or pinched by a table and so on.
Overheating may occur there, leading to a risk of fire. S-3