hp Color 9850mfp FIXING 4. Remove the fixing upper lamps 1 and 2. 5. Remove the rear side O-ring [3]. Remove the heat insulating sleeve U [4] and the ball bearing [5] at the rear side, from the fix- ing roller U [6]. Note: • Be careful not to damage the surface of the fixing roller. 6. 7. Remove the O-ring [1] and then remove the fix- Remove the fixing roller U [6]. [6] [5] [4] [3] [5] [4] [3] [2] [1] ing gear [2]. 8. After removing the O-ring [3] of front side, remove the heat insulating sleeve U [4] and the ball bearings U [5] from the fixing roller U [6]. 9. Reinstall the above parts following the removal steps in reverse. Note:
III DIS./ASSEMBLY • After replacing the fixing roller, check whether the fixing temperature sensor 3 is contacting • When fixing temperature sensor 3 is soiled with the roller. with paper dust, clean the sensor with drum [5] [4] [3] [2] [1] cleaner and cleaning pad. [5] • When having replaced the fixing roller U, be sure to make adjustments by referring to the [4] 36 mode "hp Color 9850mfp Adjustment item [3] list." Otherwise, poor images may result. • Be sure to apply the inner and outer peripher- ies of the heat insulating sleeve with Maltemp FF-RM (or, Solvent 240) before reinstalling it.
• When reinstalling them, be sure to take note of the directions of the ball bearing and the flange of the heat insulating sleeve. Reinstall them so that their upper surface turns to the inside as seen in the picture in which they are arranged after disassembly. 3-85