TRAY UP/DOWN Q5690A 6. Insert the up/down wire A [2] into the hole [1] provided on the upper surface of the HCI main [2] [7] [6] 7. body. Reinstall the up/down wire A [2] onto the guide [2] pulleys [3], [4] and [5] in this order. [1] [4] Note: • When reinstalling the up/down wire A [2] onto [3] the guide pulleys [3], [4] and [5], be sure to insert the wire into the pulley through the notch [6] provided on the side of each pulley and then move the wire cover [7] of each pul- ley to the wire that has been already inserted. When moving the wire cover [7], move it first to the position where the notch [6] can be avoided and then move the wire in the notch [5] [8] [6] into each pulley.
[2] [10] [7] [2] III DIS./ASSEMBLY 8. installation hole [9] provided at the middle of the Insert the up/down wire A [2] into the wire [6] [2] [10] [11] up/down drive shaft [8]. [8] [9] [12] Note: • The up/down drive shaft [8] is provided with 3 wire installation holes each on the front side and the rear side. In this step, the wire instal- lation hole at the middle is to be used. Since the inner-most wire installation hole has been already used, however, only two wire installa- tion holes can be confirmed for this steps. As a result, the one near to the drive pulley that has been already installed is the wire installa- tion hole [9] at the middle. 9.
Insert the drive pulley [10] into the up/down pul- ley shaft [8] so that the notch [11] of the drive pulley [10] comes to the position into which the up/down wire A [2] is put. 10. Fit the E-ring [12] to fasten the drive pulley [10]. 3-20