This section explains how to disassemble and reassemble the MFP. When disassembling and reassembling the MFP, follow the precautions given below. CAUTION G Be sure the power cord has been unplugged from the wall outlet. G The disassembled parts must be reassembled following the disassembly procedure in reverse unless otherwise specified. G Care should be taken not to lose small parts. Care should also be taken not to install small parts in wrong places. G Do not operate the MFP before installing all the disassembled parts completely. G Removal of some screws is prohibited in this section. Never loosen them.
External section Removing/reinstalling the external covers 4 Remove three screws to detach the lower cover. CAUTION Make sure that the power cord of the MFP is unplugged from the power outlet. Lower cover Screws Procedure 1 Remove cap on the top cover. Connecting cover Screw 2 Remove four screws to detach the top cover. Screws Cap 5 Remove two screws, disconnect the inline connector (CN232), and detach the control panel cover. Top cover 3 Remove one screw to detach the connector cover. 6 Reinstall the above parts following the removal steps in reverse. 18 Post insertion disassembly/assembly ENWW