Table 42. Unnumbered printer messages (continued) DRUM LIFE LOW ORDER DRUM KIT or DRUM LIFE LOW Event log message: None Description: The imaging drum is almost past its specified life. Printing can continue; however, print quality might be degraded. Action: Printing can continue until DRUM LIFE OUT message appears. DRUM LIFE OUT REPLACE DRUM KIT Event log message: None Description: The imaging drum is past its specified life or the waste toner cartridge in the imaging drum is full. Printing cannot continue until the drum kit has been replaced. Action: 1 Replace the drum kit. 2 Remove the drum cartridge from the printer, and clean the waste toner sensor window with a dry cloth.
3 Reconnect connector J221 on the controller board, and connectors J631 to J633 and relay connector J71 on the waste toner sensor. 4 Reconnect connector J209, and relay connectors J47 and J48 on the controller board. 5 Replace the drum cartridge. DUPLEX ERROR CHECK DUPLEXER Event log message: 54.00.03 6 Replace the waste toner sensor. Description: The printer has detected an error in the duplexer. Action: 1 Open the left lower cover, press the green tab on the right side of the duplexer, and pull the duplexer out of the printer. Check for and remove any jammed media from the duplexer. Reinstall the duplexer. 2 Turn the printer off and on to reset the printer. 3 Replace the duplexer.
EIO INITIALIZING Event log message: 40.00.01 Description: An EIO accessory is initializing. Action: No action is required. = EIO slot number: 1 = Bottom EIO slot 2 = Top EIO slot EN Printer message troubleshooting 397