Table 42. Unnumbered printer messages (continued) PRESS SELECT IF FUSER IS NEW Event log message: None Description: The printer has detected that a new fuser might have been installed. Action: 1 If the fuser has been replaced, press S ELECT to reset the internal counter. If the message clears before pressing S ELECT , the value can be reset in the RESETS menu. Note: This message will also occur if the printer is turned off and on and the internal fuser count indicates the fuser is near the end of its life, or the fuser door is opened. The message displays for 10 seconds. 2 If the fuser has not been replaced, press G O . PRESS SELECT IF TRANSFER IS NEW Event log message: None Description:
The printer has detected that a new transfer drum might have been installed. Action: 1 If the transfer drum has been replaced, press S ELECT to reset the internal counter. If the message clears before pressing S ELECT , the value can be reset in the RESETS menu. Note: This message will also occur if the printer is turned off and on and the internal transfer count indicates the transfer drum is near the end of its life, or the transfer door is opened. The message displays for 10 seconds. 2 If the transfer drum has not been replaced, press G O . PRESS SELECT TO INITIALIZE DISK Event log message: None Description: The printer hard disk is new or has been formatted for another file system.
Action: 1 Press S ELECT to reformat the printer hard disk. All data currently on the printer hard disk will be lost. 2 If you don’t want to initialize the printer hard disk, wait until the message clears (10 seconds) or press G O , and the disk will not be initialized. This will render the disk non- functional, but the configuration page will show that the disk is installed. 406 Chapter 7 - Troubleshooting EN