Table 42. Unnumbered printer messages (continued) TRAY EMPTY Event log message: None Description: An input tray not currently selected has run out of media. Action: 1 Load the media type and size specified on the printer control panel display. = Input tray number (2, 3, or 4) = Last media type configured for the input tray = Last media size configured for the input tray 2 Replace the upper/lower cassette lifter (remaining paper sensor lever) if it is damaged or deformed. Also, if the lifter is out of position, set it in its correct position. 3 Reconnect connector J1201 on the pick-up PCA and connector J210 on the controller board.
4 Replace the tray 2 and tray 3 remaining paper sensors 1 and 2. 5 Replace the pick-up PCA. 6 Replace the controller board. TRAY LIFTING Event log message: None Description: The specified input tray is lifting the media into position for printing. Action: No action is required. = Input tray number (2, 3, or 4) TRAY LOAD CHECK CONTROL PANEL SETTING Event log message: None Description: A user has requested a media size and type combination that is not currently installed or configured in the printer. This message is also generated when the current input tray runs out of media and no other auto-selectable input trays contain that size and type of media. Action:
Load the media type and size specified on the printer control panel display, and configure the media type in the printer control panel. After the requested input tray is loaded, the printer automatically goes online. Pressing G O causes the printer to attempt to print the page on the default type and size media. If the condition persists, check the input tray type and size configuration in the control panel. = Input tray number (1, 2, 3, or 4) = Last media type configured for the input tray = Last media size configured for the input tray EN Printer message troubleshooting 413