3,000-sheet stapler/stacker troubleshooting Calibrating the staple position Note Recalibrate the staple position only if the accumulator assembly, the carriage assembly, or the controller PCA is replaced. NVRAM located in the controller PCA keeps in memory the configured compensation values for the staple position. When the device is in service mode, you can gain access to the flexible calibration menu. To calibrate the staple position 1 Turn the printer off. 2 Enter service mode (see “To set the device in service mode” later in this chapter). As the device powers on, the NVRAM receives the calibration values.
3 After successful power on, exit service mode (see “To exit service mode” later in this chapter). 4 Turn the printer on and wait until Ready appears on the control panel display. The user LED, located at the top of the front cover, should blink green. 5 Press M ENU until Configuration of Stkr appears on the control panel display. 6 Press I TEM until Default of Staples appears. 7 Press – V ALUE + until One Staple appears. 8 Press S ELECT . 9 Press M ENU until Information Menu appears. 10 Press I TEM until Print Paper Path Test appears. 11 Print a ten-page job to the stapler bin (optional bin 1).
12 Check the staple position of the 10-page print job against the staple position in figure 239 on page 483. • If the positions are not comparable, then the device should be recalibrated; continue with step 13 below. • If the positions match or are close to a match, the device does not require recalibration; proceed to step 18. 13 Press M ENU until Configuration of Stkr appears. 14 Press I TEM until X Compensation/Y Compensation appears. 482 Chapter 7 - Troubleshooting EN