A+ Server 4020A-8R — A+ Server 4020A-8R User Manual: Comprehensive Guide for System Integrators

Chapter 5: Advanced Serverboard Setup 5-4 Connecting Cables Now that the processors are installed, the next step is to connect the cables to the serverboard. These include the data (ribbon) cables for the peripherals and control panel and the power cables. Connecting Data Cables The ribbon cables used to transfer data from the peripheral devices have been carefully routed in preconfi gured systems to prevent them from blocking the fl ow of cooling air that moves through the system from front to back. If you need to disconnect any of these cables, you should take care to reroute them as they were originally after reconnecting them (make sure the red wires connect to the pin 1 locations).

If you are confi guring the system, keep the airfl ow in mind when routing the cables. The following data cables (with their serverboard connector locations noted) should be connected. See the serverboard layout diagram in this chapter for connector locations. CD-ROM cable (JIDE#2) Floppy Drive cable (JFDD1) SCSI cables (JA1) Front Side USB cable (USB2/3) Control Panel cable (JF1, see next page) Connecting Power Cables The H8DA8 has a 24-pin primary power supply connector "J1B4" at designated "ATX Power" for connection to the ATX power supply. Connect the appropriate connector from the power supply to the "ATX Power" connector to supply power to the serverboard.

See the Connector Defi nitions section in this chapter for power connector pin defi nitions. In addition, your power supply must be connected to the 8-pin Secondary ATX Power connection at JPW2. 5-5