A+ Server 4020A-8R — A+ Server 4020A-8R User Manual: Comprehensive Guide for System Integrators

Chapter 7: BIOS System Health Monitor CPU Overheat Temperature Use the "+" and "-" keys to set the CPU temperature threshold to between 65 o and 90 o C. When this threshold is exceeded, the overheat LED on the chassis will light up and an alarm will sound. The LED and alarm will turn off once the CPU temperature has dropped to 5 degrees below the threshold set. The default setting is 78 o C . The other items in the submenu are all systems monitor displays for the following information:

CPU1 Temperature, CPU2 Temperature (for 2U systems), System Temperature, CPU1 Vcore, CPU2 Vcore (for 2U systems), 3.3V Vcc, +5 Vin, +12Vin, -12V Vcc, DDRA VTT, DDRB VTT, 1.2V for Hyper Transport, DIMM Voltage, 1.8V for chipset, 5V Standby and 3.3V Standby. System Fan Monitor Fan Speed Control Modules This feature allows the user to determine how the system will control the speed of the onboard fans. If the option is set to "3-pin fan", the fan speed is con- trolled based upon the CPU die temperature. When the CPU die temperature is higher, the fan speed will be higher as well.

If the option is set to "4-pin", the fan speed will be controlled by the Thermal Management Settings pre-confi gured by the user with this setting. Select "3-pin" if your chassis came with 3-pin fan headers. Select "4-pin" if your chassis came with 4-pin fan headers. Select "Workstation" if your system is used as a Workstation. Select "Server" if your system is used as a Server. Select "Disable" to disable the fan speed control function to allow the onboard fans to continuously run at full speed (12V). The options are 1) Disable, Full Speed 2) 3-pin (Server), 3) 3-pin (Workstation), 4) 4-pin (Server) and 5) 4-pin (Workstation). Note: the 4020A-8R should have this set to "3-pin (server)".

FAN1 Speed through FAN8 Speed The speeds of the onboard fans (in rpm) are displayed here. Note: the FAN1 through FAN5 speeds will be displayed for the H8DAR-8. 7-9