Supermicro A+ Server 4022G-6F — Supermicro A+ Server 4022G-6F User's Manual PDF Download

Chapter 2: Server Installation You should now have rails attached to both the chassis and the rack unit. The next step is to install the server into the rack. You should have two brackets in the rack mount kit. Install these first keeping in mind that they are left/right specific (marked with "L" and "R"). Then, line up the rear of the chassis rails with the front of the rack rails. Slide the chassis rails into the rack rails, keeping the pressure even on both sides (you may have to depress the locking tabs when inserting). Installing the Server into the Rack When the server has been pushed completely into the rack, you should hear the locking tabs "click".

Finish by inserting and tightening the thumbscrews that hold the front of the server to the rack (see Figure 2-4). Figure 2-4. Installing the Server into a Rack Note: This figure is for illustrative purposes only. Always install servers to the bottom of the rack first. 2-7