Supermicro A+ Server 4022G-6F — Supermicro A+ Server 4022G-6F User's Manual PDF Download

A+ Server 4022G-6F User's Manual 2-7 Checking the Drive Bay Setup Next, you should check to make sure the peripheral drives and the hard drives and backplane have been properly installed and all connections have been made. Checking the Drives All drives can be accessed from the front of the server. Servicing drives in the peripheral drive bays requires removing the chassis cover. The SAS/SATA hard drives can be installed and removed from the front of the chassis without removing any chassis covers. To install components into the 5.25" drive bays, such as a DVD drive, refer to Chapter 6 for instructions. Your system may have one or more hard disk drives already installed.

To install hard drives, refer to Chapter 6. Checking the Airflow Airflow is provided by three hot-swap 8-cm chassis fans working in conjunction with an air shroud. Two additional 8-cm exhaust fans are also mounted at the rear of the chassis. The system component layout was carefully designed to promote sufficient airflow through the chassis. Note that all power and data cables have been routed in such a way that they do not block the airflow generated by the fans. Keep this in mind when you reroute them after working on the system. Supplying Power to the System 1. Plug the power cords from the power supplies unit into a high-quality power Lastly, power up the system.

strip that offers protection from electrical noise and power surges. An uninterruptible power supply (UPS) is recommended. 2. Depress the power button on the control panel on the front of the chassis. 2-10