Chapter 5: Advanced Serverboard Setup To Install: Insert module vertically and Figure 5-4. Installing DIMM into Slot Notch Notch press down until it snaps into place. Pay attention to the align ment notch at the bottom. Front View Note: Notch should align with the receptive key point on the slot. To Remove: Use your thumbs to gen tly push the release tabs near both ends of the module. This should release it from the slot.
Release Tab Release Tab Top View of DDR3 Slot 5-9 Memory Population for Optimal Performance -For a Motherboard with One CPU (CPU1) Installed # DIMMS CPU Channel 1 Channel 2 Channel 3 Channel 4 4 DIMMs CPU1 P1-1A P1-2A P1-3A P1-4A 8 DIMMs CPU1 P1-1A P1-1B P1-2A P1-2B P1-3A P1-3B P1-4A P1-4B Memory Population for Optimal Performance -For a Motherboard with Two CPUs (CPU1 & CPU2) Installed # DIMMS CPU Channel 1 Channel 2 Channel 3 Channel 4 8 DIMMs CPU1 P1-1A P1-2A P1-3A P1-4A CPU2 P2-1A P2-2A P2-3A P2-4A 16 DIMMs CPU1 P1-1A P1-1B P1-2A P1-2B P1-3A P1-3B P1-4A P1-4B CPU2 P2-1A P2-1B P2-2A P2-2B P2-3A P2-3B P2-4A P2-4B