Chapter 6: Advanced Chassis Setup 6-2 Front Control Panel The front control panel LEDs help monitor the system status. See Chapter 3 for details on the LEDs and buttons. The control panel connects to the JF1 connector on the serverboard to provide system status indications. The red wire in the ribbon cable plugs into pin 1 on both connectors. Details on JF1 can be found in Chapter 5. Pull all excess cable out of the airflow path. Control Panel Orientation The server can be configured for either tower or server rack orientation. It is shipped in tower mode and can be immediately used as desktop server.
To use it in a rack, rotate the module that contains the control panel and the three drive trays (marked as 'A' in Figure 6-1) 90 degrees. 6-3